N2125 SAS/SATA HBA	Device Product Guide	Part Number: 46C9010 Feature Code: A3YY
PCIe Sub Vendor ID: 0x1014 PCIe Sub Device ID: 0x040D

Firmware	Firmware Name	Version
BIOS/FW/UEFI Update for N2125 SAS/SATA Controller	n2125-1.20.02-4
BIOS/FW/UEFI Update for N2125 SAS/SATA Controller	n2125-1.20.02-4
Drivers	Driver Name	Discreate Package Download	Version
mpt3sas kernel driver	kmod-mpt3sas-28.00.03.00_el8.0- 2.x86_64.rpm	28.00.03.00_el8.0
InBox Driver provided by Linux Distro install supported

Firmware	Firmware Name	Version
BIOS/FW/UEFI Update for N2125 SAS/SATA Controller	n2125-1.20.02-4
BIOS/FW/UEFI Update for N2125 SAS/SATA Controller	n2125-1.20.02-4
Drivers	Driver Name	Discreate Package Download	Version
mpt3sas kernel driver	kmod-mpt3sas-28.00.03.00_el8.0- 2.x86_64.rpm	28.00.03.00_el8.0
InBox Driver provided by Linux Distro install supported

BIOS/FW/UEFI Update for N2125 SAS/SATA Controller

Controller Supported: IBM N2125 SAS/SATA Controller (46C9011)

NOTE TO SERVICE - Reference RETAIN #N/A

Version 1.20.02-4 - Moderate Impact/Low Probability of Occurrence
---------------
Contains:
BIOS Firmware UEFI Driver
07.39.00.00 20.00.02.00 07.27.04.00
fix:use pkgsdk4.16,it support os(sles15,windows 2019)

Version 1.20.02 - Moderate Impact/Low Probability of Occurrence
---------------
Contains:
BIOS Firmware UEFI Driver
07.39.00.00 20.00.02.00 07.27.04.00

Fixes:
- SUT hang when click start /locate for PD in UEFI or click SAS Topology in legacy option rom w/D3284 (Bug 122486)

Version 1.20.01 - Moderate Impact/Low Probability of Occurrence
---------------
Contains:
BIOS Firmware UEFI Driver
07.39.00.00 20.00.02.00 07.27.04.00

Enhancements:
- Added System X agentless support
- Indicate support for the ATA Device Server Password security protocol
- Allow UEFI and BIOS to be Enabled/Disabled individually
- Added ConnectorName and EnclosureLevel fields to SAS Device Page 0 to
help identify physical location of a target device
- Set SATA HOLD threshold to be configurable in NVDATA
- If HW can gets into a stuck state, clear that state upon break received.

Fixes:
- Set SAS drives to track bad blocks using a bad block table rather than
using a SCSI Write Long.
- Fixed DMAGroup performance issue.
- Fixed issue with Phase 18 IR FW boot a RAID volume (such as raid 10),
2308 bootup hangs at OROM "Initializing.." and fault 8803 seen.
- Fixed report Luns command to a SATA drive fails with
CheckCondition/Invalid Field in CDB when Allocation length set to Zero.
- Fixed issue where Raid Accelerator IOs can hang if the stream of IOs
suddenly stops.
- Fixed issue where an invalid frame sent during a PIO-mode SATA
passthrough command results in resetting the drive.
- Fixed issue where lots of NCQ I/O error messages were reported.
- Fixed issue where certain PCIe timeouts occur in the presence of link
unavailable, and a hang condition or data corruption can occur.
- Fixed issue where system hangs after adapter reset with heavy IO load.
- Fixed issue where access to Last Logical Block Address (LBA) of SATA
Drive is Prevented and LBA out Of range by one block is missed.
- Made change to deal with link getting stuck and causing missing drives.
- Fixed IR issue where page header information is not filled in when RAID
PHYS DISK PAGE 0 is returned for a non-RAID Disk drive.
- Fixed issue where controller hits 0x265d fault while creating volume
when there is an inactive volume.
- DID_SOFT_ERRORs are seen when hot plug is performed on the RAID1 volume
along with IOs.
- Fixed issue where system gets hung and reboots while running IO's along
with diag reset on the Controller which has active and inactive volumes.
- Fixed latency spikes seen during performance testing on OEM system
- MPI 2.5: distribute target command buffers received across multiple
reply queues.
- Fixed issue where command sas2flash -dflash results in a non-functional
system.
- Fixed issue where internal device reset storm after controller reset
using long CDB.
- Fixed 0x6003 Fault Due to Task Management of Lost IO
- Fixed 0x58A1 fault occurs on partner controller while issuing MUR to a
target mode controller with outstanding IOs.
- Fixed issue where IO error and stop when hot plug a HDD from RAID1
- Fixed issue where fault 8901 is seen once the volume is roamed.

Version 1.18.01 - Initial release
-------------
Contains:
BIOS Firmware UEFI Driver
7.35.01.00 18.00.00.00 7.25.04.01

Linux
Enhancement:
- Add support for RHEL 7

Lenovo Data Center Group Linux OS Support Home Page

linux.lenovo.com

LSI HBA and HBA/LSI Onboard 12Gb SAS/SATA/SSD Driver for RHEL8

12Gb HBA SAS/SATA/SSD Driver for Linux

Supported Controllers: 
 - N2215 SAS/SATA HBA (47C8676)
 - N2225 SAS/SATA HBA (00AE912)
 - N2226 SAS/SATA HBA (00AE916)
 - ThinkSystem 430-8i SAS/SATA 12Gb HBA
 - ThinkSystem 430-8i SAS/SATA 12Gb Dense HBA
 - ThinkSystem 430-16i SAS/SATA 12Gb HBA
 - ThinkSystem 430-8e SAS/SATA 12Gb HBA
 - ThinkSystem 430-16e SAS/SATA 12Gb HBA

Supported Kernesls:  RHEL 8
						  
version	28.00.03.00	 -- Moderate Impact/Low Probability of Occurrence
-----------------------

Lenovo Data Center Group Linux OS Support Home Page

linux.lenovo.com