Lenovo YUM Repository
Release and Change History








Bundle Release Information:
Targeted Server Family (Machine Type): ThinkSystem SR655 (7Y00, 7Z01)
Targeted Operating System: SLES12SP5
YUM Repository Build Date: 2021_09_13

YUM Repository Release Version: 21C

Device:
ThinkSystem RAID 930-24i 4GB Flash PCIe 12Gb Adapter

Device Product Guide

Part Number: 7Y37A01086
Feature Code: AUNJ
PCIe Sub Vendor ID: 0x1D49
PCIe Sub Device ID: 0x0603


Release History:

Release Change History Documents

Expander Firmware Update for ThinkSystem RAID 930-24i 4GB Flash PCIe 12Gb Adapters (For Linux)



Expander Firmware Update for SAS Expander PsoC

Supported Adapters:  
		SAS Expander PsoC  for  NA-930-24i-exp

NOTE TO SERVICE - Reference RETAIN #N/A

Version 125.16.01.00 - New Function Only/No fixes
-------------------
Firmware Image:  125.16.01.00

Defects:
-Expander FW initialization code dereferences null pointer after null check.(DCSG00415838 (Port Of Defect DCSG00421214))
-Watchdog Status sometimes doesn't show valid Reset Status value for Expander soft reset.(DCSG00501521 (Port Of Defect DCSG00507130)
-SDK does not recover the PHY when the SPICO_ECC fault (0x175) is reported.(DCSG00411475 (Port Of Defect DCSG00507124))

EnhancementRequests:
-Add Tx FIFO flush logic to the ISTWI master arbitration lost handler.(DCSG00778893)
-Added support to report Invalid BaySlotNumber/ConnectorElementIndex 0xFF when the expander doesn't get the slot number from the UBM backplane.(DCSG00930877 (Port Of EnhancementRequest DCSG00935402))


Version 125.16.00.00 - New Function Only/No fixes
-------------------
Firmware Image:  125.16.00.00

Defects:
-Partial Error Log Header Causes Firmware Fault.(DCSG00106334)
-Multi master I2C communication within 2 expanders using I2C packet layer fails on one expander reset..(DCSG00110208)
-I2C communication within 2 expanders using I2C packet layer fails on one expander reset.(DCSG00112595)
-If the amount of information requested exceeds the size of the config page, Exp FW terminates the command with CHECK CONDITION status for buffer ID 0xE6.(DCSG00205352)
-Add note in Exp XML 'Spinup Control Configuration Page (0xFF0A) and prog guide that Exp 'spin-up' and 'phy reset in progress timeout' setting should be in sync.(DCSG00218728)
-The SAS35Xnn expander is unresponsive to CLI or in-band interfaces during stress testing with watchdog and phy resets.(DCSG00219838)
-Expander may exhibit issue if multiple hosts try to do config page read/write operations concurrently.(DCSG00226514)
-When in-place concatenated image is active, log shows that the MFG image is unreadable.(DCSG00234564)
-Executing rapid phy resets causes expanders to exhibit inappropriate behavior.(DCSG00242358)
-I2C master fails to communicate with peer expander I2C slave with master power cycles test..(DCSG00242592)
-Assert observed in ISTWI Slave module in a stress test involving peer master power cycle..(DCSG00243797)
-NULL pointer could have been de-referenced for reading while tracing firmware flow in the API that creates the transaction context for SSPI.(DCSG00249050)
-Expander FW does not set warning/critical field even though Voltage sensor element reports critical status.(DCSG00253035)
-Write Buffer command with size/offset beyond the allowed buffer size give incorrect response.(DCSG00253043)
-Remove unnecessary #include "../include/aapl/aapl.h" from halPhyConfiguration.c.(DCSG00257751)
-When 0.15.203.00 version of expander FW is active on CubR boards, Scrutiny CLI's 'show' command doesn't complete.(DCSG00264968)
-Compilation failure seen while creating in-place concatenated image.(DCSG00266712)
-Config page write using buffer ID 0xE6 failed..(DCSG00394079)
-Unsupported vendor specific commands return INVALID FIELD IN CDB as the sense code.(DCSG00118485 (Port Of Defect DCSG00103403))
-INVALID COMMAND OPERATION CODE is returned as Additional Sense Code for unsupported SES Page..(DCSG00119142 (Port Of Defect DCSG00103326)
-Fault in halSspIisr.c.(DCSG00143502 (Port Of Defect DCSG00093790))
-Update from Pre-Phase 9.0 fw to Phase 9.0 or later results in 0x175 Fault.(DCSG00153880 (Port Of Defect DCSG00132832)
-Watchdog reset is seen with Peak Value Detection configured for Databolt enabled PHYs..(DCSG00304554 (Port Of Defect DCSG00259162))

Enhancements:
-Add note in expander config XML and programming guide that expander 'spin-up' and 'phy reset in progress timeout' MFG config setting.(DCSG00164169)
-Upgrade Vero-24i code base to Cub PH16 SDK equivalent.(DCSG00433512)


Version 125.14.02.00 - New Function Only/No fixes
-------------------
Firmware Image:  125.14.02.00

Defects:
-The SAS35Xnn expander is unresponsive to CLI or in-band interfaces during stress testing with watchdog and phy resets.(DCSG00219838 (Port Of Defect DCSG00256759))
-Fault in halSspIisr.c.(DCSG00093790 (Port Of Defect DCSG00106459))
-Multi master I2C communication within 2 expanders using I2C packet layer fails on one expander reset..(DCSG00110208 (Port Of Defect DCSG00112750))
-I2C communication within 2 expanders using I2C packet layer fails on one expander reset.(DCSG00112595 (Port Of Defect DCSG00258182))
-Update from Pre-Phase 8.0 fw to Phase 8.0 or later results in 0x175 Fault.(DCSG00132832 (Port Of Defect DCSG00164299))
-Watchdog reset is seen with Peak Value Detection configured for Databolt enabled PHYs.(DCSG00259162 (Port Of Defect DCSG00301911))

EnhancementRequests:
-Port Vero to latest Cub PH14 based release for 20C release.(DCSG00124781)


Version 7.2.1.9 - New Function Only/No fixes
-------------------
Firmware Image:  125.14.01.00
No fixes

Version 7.2.1.8 - New Function Only/No fixes
-------------------
Firmware Image:  125.14.01.00

Version 7.2.1.6 - New Function Only/No fixes
-------------------
Manufacturing Image:  01.07
Firmware Image:  125.10.01.00

defects:
- Phase3 Beta Release Version 0.02.208.00 - SAS35XFW_Phase_4.0 (1).(SCGCQ01320855)
- Phase4 Pre-Alpha Release Version 0.03.200.00 - SAS35XFW_Phase_4.0 (1).(SCGCQ01303680)
- Alpha Release Version 0.03.203.00 - SAS35XFW (1).(SCGCQ01324632)
- Alpha Release Version 0.04.202.00 - SAS35XFW (1).(SCGCQ01400054)
- Pre-Alpha Release Version 0.05.200.00 - SAS35XFW_Phase_5.0 (1).(SCGCQ01456174)
- Alpha Release Version 0.07.202.00 - SAS35XFW (1).(SCGCQ01745766)
- Phase8 Beta Release Version 0.07.208.00 - NETX (2).(SCGCQ01830463)
- Phase9 Alpha Release Version 0.08.202.00 - SAS35XFW (2).(SCGCQ01857883)
- Phase10 Pre-Alpha Release Version 0.09.200.00 - SAS35XFW (1).(SCGCQ01923237)
- Phase10 Pre-Alpha Release Version 0.09.201.00 - SAS35XFW_Phase_10.0 (2).(SCGCQ01932353)
- Phase10 Alpha Release Version 0.09.202.00 - SAS35XFW_Phase_10.0 (1).(SCGCQ01944440)
- Beta Release Version 0.09.204.00 - SAS35XFW_Phase_10.0 (1).(SCGCQ01985705)
- Phase10 Point Release Version 0.10.01.00 - SAS35XFW_Phase_10.0 (1).(SCGCQ02003728)
- Phase11 Pre-Alpha Release Version 0.10.200.00 - ComboSerdes (1).(SCGCQ01999043)
- Point Release Version 11.140.00.00 - ComboSerdes (1).(SCGCQ02108878)
- Point Release Version 1225.08.02.00 - SAS35XFW_Phase_6.0 (6).(SCGCQ01982336)
- Alpha Release Version 125.08.00.00 - SAS35XFW_Phase_6.0 (17).(SCGCQ01936908)
- Point Release Version 125.08.02.00 - SAS35XFW_Lenovo_Vero_24i (4).(SCGCQ01982453)
- Point Release Version 125.10.01.00 - SAS35XFW_Phase_10.0 (25).(SCGCQ02044925)
- Pre-Alpha Release Version 125.11.200.00 - SAS35XFW_Phase_9.0 (24).(SCGCQ02122045)
- Beta Release Version 65.02.05.00 - SAS35XFW (1).(SCGCQ01316960)
- Phase4 Point Release Version 65.04.15.00 - SAS35XFW_Phase_4.0 (2).(SCGCQ01587050)
- Phase4 Point Release Version 65.09.16.00 - SAS35XFW_Phase_4.0 (16).(SCGCQ01966789)

Version 7.2.1.5 - New Function Only/No fixes
-------------------
Manufacturing Image:  01.07
Firmware Image:  125.08.02.00

fixes:
      SCGCQ01600459: Re-enables EDFB on 9365-28i Cub Expander (Lenovo 19A) and includes binary image。
		 
Version 7.2.1.3 - New Function Only/No fixes
-------------------
Manufacturing Image:  01.07
Firmware Image:  125.03.03.00

Fixes:
    Update Firmware fail.

Version 7.2.1.1 - New Function Only/No fixes
-------------------
Manufacturing Image:  01.07
Firmware Image:  125.03.03.00





Lenovo Data Center Group Linux OS Support Home Page
linux.lenovo.com

© 2018-2021 Lenovo. All rights reserved